Listing Open
Free, zero, We want them GONE!
The 2 Makerbots are working, however they are very old (circa 2012). We also do have some replacement nozzles for them!
They do not have heated beds which would make doing large and flat prints a challenge without excessive glue or tape. They also have noisy motors. They do not run modern slicer software (but it can still be downloaded).
The red Flashforge is also very old and has a dead logic board. Parts from the manufacturer are no longer in production, however, It might be able to source from NOS, or 3d party. We recommend its best use as a parts device. This printer also does not have a heated bed, so glue is your best way to get it to work. It has a a small build area and also does not run modern slicer software (but it can still be downloaded).